Wall Mounted Hairdryer WM6C
Today’s information is about the Wall Mounted Hairdryer Model WM6C.
This 1200 watt hairdryer has a long proven track record being in service for over 10 years in Australia. Jerdon is a US based company had until just recently, marketed these dryers under the Jerdon First Class branding. Jerdon has been working on different models and have decided to relaunch the entire range of driers as Pro Versa by Jerdon.
This 1200 watt wall mounted hairdryer is essentially exactly the same as the First Class except for the new branded logo.
Dimensions on this WM6C Wall Mounted Hairdryer are not mentioned on the downloadable PDF they are as follows-
The driers sits in a vertical position and measures vertical Height is 20cm Width is 8.7cm Overall Depth is 10.5cm.
Curly cord from cradle body to hand piece is 30cm but can stretch to 150cm (this is not normal) just its capability. The power cable will reach a maximum of 90cm from the cradle body to a power point. To shorten the length of this cord is a simple matter of using the wrap around guides in the back of the drier to adjust the cord to any length. Should you need a different set up an electrician is required to shorten the cable.
Please note if you are installing this hairdryer for the first time you should make sure the Handpiece cannot fall in any water such as the sink, bath, and toilet or be in reach where it can be used inside a shower.
Experience tells us that the location of this hairdryer is one to think about as generally your guest like to use the dryer in front of a mirror. If your mirror is located to far away guests tend to stretch the curly cord to use it in front of the mirror. It will retract but after constant use however it tends to stay stretched. If your wall mount hairdryer is in a funny position when replacing the handpiece back into the body then the small house shaped location lugs tend to get bent making it that little bit harder to put the handpiece back. Good location will avoid these issues.
The unit is built with a high heat overload switch so if it does have extended use it will cut out and normally reset after 10 minutes. The WM6C wall mounted hairdryer has a 12 month limited warranty. Meaning it does not apply to misuse or abuse but rather to material defects or workmanship. There is a full Use and Care book enclosed with every drier.
The Use and Care booklet has mounting instructions included. Wall mounting is by a steel wall plate screwed to the wall which the main body of the drier clips into. Guests would find it’s difficult if they are trying to remove the unit. Should a replacement be required you do not need to re drill the tiled wall in your bathroom to put up the new dryer. The steel bracket design has not been changed so just unclip your old drier and place the new one on the same bracket. This wall mounted hairdryer WM6C has a removable hair and fluff filter on the rear remember it will operate a lot better with a clean filter.
The strongest selling point for these Wall Mounted Hairdryers
If they are setup in the correct position then you should get over 5 years service. This is pretty good for a hospitality drier which tend to get broken and stolen more often that other items in the room. Simplicity for the guest is always the best thing for tired travellers. Being a wall mounted hairdryer they are seen as a fixture and not be mistaken as their own and it get packed in the bag and leaves your property.
Regards
Team JK